Grim_d's gtir

Mine will be back on next week so no harm done, on the plus side it's drivering well an looks as if it's going to make power easily with little boost.

What power are you hoping for at what boost? You have a 3" exhaust don't you?

I'm hoping for 400 at around 1.2.- 1.3

Yeah I have full 3" and a decent mani.

You should see it easily. Not aiming for more?

Yeah I'll push for more, just want to get it settled and some miles on it

What torque figure did it put out graham?

Also what turbo housing you using on the 3071

Don't know unfortunately, it was a hired dyno but the normal operator was unavailable and my mapper uses dynapack hub dynos so nobody was sure how to change the graph from bhp/afr I've still to chase it up as left the graph with them but the whole point of the session was to just sort the car out so not too bothered.

Again don't know, made a thread on how to identify but couldn't get anywhere, can't see any distinguishing marks.

I won't be buying another built car, too many unanswerable questions!

You should be able to see what housing it is on the cold side of the turbo, I have a 3071 and it says It very clearly on the side! Hope this helps?

Doesn't say what size the exhaust housing is though and I can't see the ID plate, if there is one.

Off the top of my head the Id plate is at the back where the oil feed runs to, so would have to take it off

The only way I thought might work would be to measure the width of the housing as a. 86 should be wider,  not likely to be very accurate though.