Turbo

Oh right any builds i have done ive never lined them up just staggered them intially  as thats how i found them ..but read as they can move its not that dead important exact postioning of them .....im no expert engine builder lol

Well that's one back in going to do the other two tomorrow as its dark out side can't see much

You need to eat more carrots scotty 

Lol it's hard stuff seeing in the dark when your doing it on the street with no street lights either:( joys of staying in the middle of no where lol I couldn't be arsed getting the extension cables out to plug in lights either was the good old touch on the iPhone

Lol im the same its always the running joke with my friends that we cant start anything until its dark .....good old phone torch apps 

I thought about buying a gazebo and kitting it out with some lights wind and water tight for much cheapness lol

I bought one to use when i get round to spraying it ....

Cosworth head gaskets yes/no or any use recommend?

yep there fine just make sure your head is flat as theres little leaway for warpage with an mls gasket, if in doubt get a light skim

What do you think of standard head gaskets or just fire a up rated one on?

if its running no big power then put a stock hg on it, its a little more forgiving with any warpage as it will compress .2mm when torqued up

Just thinking money wise also spend minimum on it get it back on the road have a bit fun then rebuild it in a year or two sound good to you?

Ill be running about 0.9 to 1bar off boost will the standard h/g handle that ok?

no problem put a stock hg on it that will be fine.
if reusing the stock headbolts on the last torque setting give them an extra 5 degree turn


oh and btw I was correct with the bigend tightening torques I said in earlier post as just checked for you

Aww cheers mate I'm Working till 5 home for half 5 the other two pistons out then see what I need then will sort out an order with you I need a knock sensor mines is all cracked

Alright folks  tow choice off a h/g 

This one 
http://www.ebay.co.uk/itm/350501659475?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

Or this one?

http://www.ebay.co.uk/itm/170928887698?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649


Will they both fit?

do not use the cometic hg

I bought some of those victor reinz hg and fitted 3 so far and I personally think they are better quality than the stock Nissan ones so would deffo recommend using them.
you will need to open up the dowel holes slightly though with a dremmel as they are a bit too small like the cosworth hg

Aww that's cool mate nice and cheap for me then

yep cheap and seems a good bit of kit

After I've rebuilt the pulsar what engine oil should I run just normal stuff or build oil? Thanks scott

just use 15w/40 mineral based oil that will be fine