Gtir Motorsport club
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Gtir Motorsport club

Welcome to the largest Nissan Pulsar & Sunny GTI-R Forum. Masses of info, friendly members, cars for sale, lots of spares. Best forum on the net by far. Everything your gtir needs is here.


You are not connected. Please login or register

ecu fault code check

Go down  Message [Page 1 of 1]

1ecu fault code check Empty ecu fault code check 9th March 2012, 5:42 pm

Admin

Admin
Admin
Admin

Switch ignition on but don't start the engine. In the grey plug under the fuse box, connect the two right pins (chk and ign) with a paper clip for example, for 3 seconds (the engine check light will turn off while you are shorting them out). The engine check light will flash a series which will indicate a code -
Long long long long long (pause) Short short short short short - indicates 55 which is no fault.

If it flashes 3 long and 4 short for example it's the Det sensor.

To clear the ECU codes, short the wires out again while it is flashing the code.


ecu fault code check Ecu_code_plug
ecu fault code check Zi1
ecu fault code check Fault20check

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum