fitting side skirts

Good luck mate
Lube or try one I know they need to be tight once in but even very gone sand the male one if you get stuck

Thanks mate

Went to order more clips and they are out of stock from Nissan.

I tried to fit one side skirt this arvo, with the both clips attached to the side skirt and some went in but not enough to hold the side skirt correctly to the car. It looks like my problem is the sill is actually push in around the side skirt holes from someone trying to fit them previously, I'm guessing brutally with a hammer. So the clips wont sit into the sill

I haven't tried the other side. I'm going to glue them and forget about it

sounds like you'll be buying some tigerseal shortly then 

Stu wrote:These are what I bought.
http://www.ebay.co.uk/itm/122023181034

Thanks Stu I just order some of these. So much cheaper than Nissan aswell.

I had a new thought this arvo, I'm going to wedge metal or cardboard behind the male clips (similar to the pic below) to hopefully give the clip a few move mm to push in, I'm hopeful this will solve my problem

Use plastic
carboard might dissapeer eventually but holds water and a metal thin enough will prob rust
I know your not in the U.K. but paint or protect around them with sealer

That's a good point mate, thanks!