Is there a way to test a MAF

Hi guys 
Is there a way i can test if my Z32 is ok? 
Thanks Glenn

Voltage is one way i think 

Err avcr or safc will give a read out or can u pin the cables then test with a multi meter or i am sure there is a dead reading ie ohms  

This info is just something i remember could be wrong try googling some of the above might help

http://www.sxoc.com/vbb/showthread.php?443314-Simple-Z32-maf-test

Yep 0.5 v rang a bell. Whats the reason you think its not right glenn or you just checking ?

I def have a maf issue, i have just rewired, i have 0.5v on signal, 12 on live and ground bells to chassis, going to bolt bits back on and try, car juat wont idle but could be timing just dies haha

You tried cleaning it i use carb cleaner then contact cleaner as it evapourates all the crap off the hot wire. What happens when its unplugged ?

Right iv rewired, cleaned connections bla bla, got it running have taken down the road fine just idles abit off, i think this is down to timing as it near enough idles now. Good news i think  

Good stuff hope so keep us updated.

So was it wired in wrong glenn ? ..... yes acetone( nail polish remover) is a good cleaner and cheap

To be honest i am not sure i just took all apart and started from scratch  booked car to be looked over and tuned next thursday to see where i go from there

check your dump valve aswell, i thought my maf had gone bad but it aint think its a leaky dumpvalve

I have blocked it off at the mo, going to plumb back in the standard re circ valve before getting tuned. Pretty sure was maf related as it drives ok just idle rough.