cv boot replacement

as title, hows it done and any special tools needed?

thanks in advance

This is a good how to guide on the site. (For the front ones)

http://www.gtir-motorsport-club.com/t395-cv-joint-driveshaft-gator-renewal

Deep 32 mm socket

Circlip pliers a deep 32mm socket but check first as the newer driveshaft nuts can be different size like mine was .... the driveshaft nuts are normally pretty tight so a good breaker bar is also needed ....

nomad wrote:Circlip pliers  a deep 32mm socket but check first as the newer driveshaft nuts can be different size like mine was .... the driveshaft nuts are normally pretty tight so a good breaker bar is also needed ....

And if you are on your own, loosen this one before you jack it up...

Of course i think i did mention that on the how to i did ....

I'm sure you did - it just proves I haven't read it all the way through yet, I just look at the pictures...  

ah i didnt think to check the how to's seems simple enough, cheers guys and cheers nomad for the write up

Same as mate pictures are much better than words lol ... your welcome sye .... im going to do a few more when i get chance as it helps members out gives them abit of confidence to try a job themselves ....