Intake manifold gasket

So my inlet manifold gasket turned up yesterday and i left it in the wrapping as you would for safe keeping,
anyway to cut a long story short my missus has folded it in half and put it in the bin
just woundring can i still use it or is it Donald ducked???

no I would not use her again get rid lol. As for the gasket sounds a silly question which bit got folded the little joins or a ring (circle) part ?

She went straight away johnny, no not the rings, the bit in between.

ha ha. see what others think I would say its fine as seen on others where ther in two bits as long as the ring parts line up and seal. get a second opinion as I am not 100% mind

I will post a pic when i can

It will be fine as long as Johnny said it's not folded on the bits around where the main seals are

I best let her back in from outside then, i will post a pic later just to make sure.

Just beat her for being so stupid
Don't let girls touch your car stuff that's the no1 rule lol

Balls it is on the rings

Can't see by that photo too well but looks ok to me plus it will squash out when it's bolted up if it's an mls gasket

Its near the top of the ring its not super bad, just dont want to put it on if its going be no good!

maybe a tiny tiny bit of sealant wher the kink was. its half way she can sit on door step with door quarter open but if moths or cold get in she is out again

what did you pay and how long to get it ? would be my question to weather I would try using it but should be ok small bit of sealant as said

You could say it was damaged in the post