Trim clips

Hi all, sorry, I've not got my car but I know I need trim clips.
The long oval ones for sills and the smaller square ones for interior. Does anyone know how many I need to get hold of each?

Just on a buying spree ready for getting the body back next month. Gaskets falling out my arse atm.

These?

https://www.ebay.co.uk/itm/NISSAN-SUNNY-PULSAR-GTIR-INTERIOR-EXTERIOR-SILL-ETC-TRIM-CLIP-0155306611/233578324650?epid=1616277572&hash=item36625a62aa:g:X0kAAOSwDFxer~64

Zia

Zia wrote:These?

https://www.ebay.co.uk/itm/NISSAN-SUNNY-PULSAR-GTIR-INTERIOR-EXTERIOR-SILL-ETC-TRIM-CLIP-0155306611/233578324650?epid=1616277572&hash=item36625a62aa:g:X0kAAOSwDFxer~64

Zia

Yeah, those ones and possibly the smaller ones too.

I need to buy X amount, just need to know what X is.

Nissan fast part software will show quantities per diagram
or nissan4u website
http://nissan4u.com/parts/sunny/er_n14/1992_2/type_23/
find the part in question, look uo the clips it uses and note stated quantity .

Mr B wrote:Nissan fast part software will show quantities per diagram
or nissan4u website
http://nissan4u.com/parts/sunny/er_n14/1992_2/type_23/
find the part in question, look uo the clips it uses and note stated quantity .

Thanks, didn't know about that site.

10 clips needed total for skirts
http://nissan4u.com/parts/sunny/er_n14/1992_2/type_23/body_side_and_rear/body_side_trimming/

good job

we want pictures when it out from body shop

Mr B wrote:good job

we want pictures when it out from body shop

Naturally! I'm amassing quite the picture collection. I might just imgur the lot into an album.

Working on the engine at the moment, just an outside strip, clean, paint etc... some stuff getting replaced like gaskets on the inlet and the water pipes and vac lines too. Waiting for my chain to arrive so I can hoist it up a few inches to pull the box off and check the clutch and fly. I borrowed one to get it on my car wheel trolley but it's in use now so can't borrow it again.

Any ideas on where I can attach mounts to when exhaust and inlet are removed? I got one of those balance adjusting ones you attach to the crane but I think it comes with hooks so I might need to dig through the metal and find some brackets if I need to bolt it