Transfer box case

Managed to pull case apart while taking gearbox off, can't seem to push case back onto bearing and don't want to damage anything, how do I put it back on ? Thanks

I had the same problem doing mine, took a bit of jiggling around for about 30mins whilst trying to reseat the bearing from the diff casing end seemed to do the trick or I was just lucky!!

Check my thread out it has a picture of the diff end with the bearing/gearing showing I just put a drift in the end and wiggled it about whilst my mate was pushing from the other side?

http://www.gtir-motorsport-club.com/t4617-gearbox-change

I did try to push it back on but ended up taking transfer out and removing cover completely so I could clean and seal it, I'll have to have another attempt , thanks

[url=https://servimg.com/view/19185294/6][img]http://i19.servimg.co

I had the same problem while removing the gearbox , ended up fitting fitting a spare transfer box

Also try rotating the crank pulley at the same time as I did that to refit the diff shaft and also the gearbox and it seemed to make reassembly easier?

Spark plug spike wrote:Also try rotating the crank pulley at the same time as I did that to refit the diff shaft and also the gearbox and it seemed to make reassembly easier?

Will do , thanks

Your link didn't work but I sussed it out

https://servimg.com/view/19185294/6

Spark plug spike wrote:Your link didn't work but I sussed it out

https://servimg.com/view/19185294/6

Thanks, I'm going to try and get it on after work by using a rubber mallet and tapping around the case.